Gima 35145, User Manual

Page: 201 / 268

65
13.3 CO
2
Sensor Connection
13.3.1 Sidestream CO
2
Sensor Connection
Demonstration for Sidestream CO
2
Sensor Connection
1. Take out the CO
2
Sensor and insert the CO
2
Sensor Cable into the connector labeled “CO
2
” on the con-
nector panel of the monitor;
2. The sample cell of the sampling cannula must be inserted into the sample cell receptacle of the CO
2
Sen-
sor. A “click” will be heard when the sample cell is properly inserted, then connect to the airway tube. After
finishing sensor connection, and make sure that the air input end is exposed to room air and away from all
sources of CO
2
, including the ventilator, the patient’s breath and your own. Next, turn on the CO
2
switch at
CO
2
Setup Screen and then wait 2 minutes for the sensor warm-up.
3. Default Tubing Configuration
Adapter and Sampling tube (Single patient use)
Extending airway tube for connecting to sampling tube (Single patient use)
Wye Connector
Dehumidification tubing Sampling adapter Sampling tubing Filter Sampling cell