56
(A) Hold the sensor with its opening towards the patient’s finger, the sensor should be oriented in such a way
that the sensor side with a fingertip sign is positioned on the top.
(B) Insert the patient’s finger into the sensor until the fingernail tip rests against end of the sensor. Adjust the
finger to be placed evenly on the middle base of the sensor. Direct the cable along the top of the patient’s
hand. Apply adhesive tape to secure the cable if necessary.
Type 4: Y-type Adjustable Neonate SpO
2
Sensor
Type 5: Y type Neonate SpO
2
sensor
1) For correct placement on foot, place the sensors on the outside of the foot behind the pinky toe. Make sure
the sensor touches the skin closely, then secure the foot wrap with Velcro. Do not over-tighten.
Left foot (wrap goes under the foot) Right foot (wrap goes from top of the foot)
Light source (round)
Y type sensor
Foot wrap
Receiver (square)
Ankle wrap
Sensor adapter: wrapper
Y type sensor
Pinky toe
Foot wrap
Pinky toe
Foot wrap
Ankle wrap
Ankle wrap
Summary of Contents for 35145
