Gima 35145, User Manual

Page: 257 / 268

121
27.7 Alarm Problems
27.8 Power Supply Failure
27.9 Troubleshooting of IBP
.
Symptoms Possible cause Correction action
The alarm LED does not light Main board is defective Replace the main board
No alarm sound is issued Audible alarm is disabled
Check is the “ ” is displayed,
if yes, the audible alarm is disabled.
Speaker is defective Replace the speaker
Main board is defective Replace the main board
Symptoms Possible cause Correction action
Battery cannot be recharged
and/or fully charged
Battery is defective Replace the battery
Main board is failure Replace the main board
Symptoms Possible cause Correction action
Unable to calibrate
Equipment malfunction
The pressure hardware may be faulty. Contact the manu-
facturer or your local dealer.
Out of range
Confirm that you have selected the value for calibration
value that you applying to the transducer, and repeat the
calibration.
No transducer
is detected
Check that the transducer is connected and try again.
Unstable signal
is measured
Confirm that there are no disturbance to transducer, and
repeat the calibration.
Perform zero first No valid zero. Zero the transducer first.
Unable to zero
Equipment malfunction
The pressure hardware may be faulty. Contact the manu-
facturer or your local dealer.
Excessive offset
Confirm that the transducer is vented to air and try again.
If this fails, the hardware may be faulty, please change a
new adapter cable and try again. If it fails, change a new
transducer and try again. If it still fails, please contact the
manufacturer or your local dealer.
Unstable signal
is measured
No transducer
is detected
Check that the transducer is connected and try again. If
this fails, exchange the adapter cable and try again. If this
fails, exchange the transducer.
Plusatile pressure
Confirm that the transducer is vented to air, bot to the pa-
tient, and try again.