Sportsound SSR-200 Gen II Quick Start Guide
DD3159573
Rev 02
01 April 2019
201 Daktronics Drive Brookings, SD 57006
www.daktronics.com/support
800.325.8766
Page 1 of 5
This guide will assist with starting up and operating a Sportsound
®
SSR-200 Gen II audio rack. For detailed operation, configuration, and
Sportsound Rack SSR-200 Gen II Operation
.
Setup
Place the rack on a flat, sturdy surface. Remove the cover pieces and
set aside. Accessories are located in a separate case.
1.
Announcer’s Interface setup is described below. Refer also to the
quick guide (
DD3083838
) shipped with the device.
a.
Connect the 2' (610 mm) XLR cable between the microphone
and the
MIC 1 INPUT
jack.
b.
Connect headphones to the 1/4" or 1/8" jack.
c.
Connect the provided 12 VAC wallpack transformer to the
power input jack, and then use the tab above the power jack
as a strain relief for the power cord.
2.
Connect the 15' (4.6 m) XLR cable from
MIC 1
&
AUX 1
on the
announcer’s interface to
MIC 1
&
AUX 1
on the left side of the rack
(when viewing from the front).
3.
Connect the 25' (7.6 m) XLR cable between the
AUDIO OUT
jack
on the left side of the rack and the
SYSTEM AUDIO
jack on the
bottom of the fiber box. If there is no fiber box, as in an indoor
audio system, the cable will typically connect to a wall plate
junction box instead.
4.
Connect one end of the 5' (1.5 m) XLR cable to the LTIBLOX Laptop
Interface and the other end to an open
MIC
input on the mixer.
The 3.5 mm plug may be connected to the headphone jack of a
laptop or MP3 player.
5.
Route the 3-prong power cord through the access hole in the
right side of the rack, and plug into a standard outlet. Ensure the
announcer’s interface and fiber box (if included) also have power.
6.
Turn on the power strip.
7.
Switch the
AUDIO SIGNAL
to
ON
.
Ensure all antennas are pointed up and angled
outward at ~45°. Alternately, coaxial cable from the
high gain antenna kit may be connected into
WRX A
and
WRX B
. The antennas should be located within 50'
(15.2 m) of the rack, using desktop stands or mounted
to the ceiling.
Announcer’s
Interface (Gen II)
1
2
Laptop
Interface
Side View
Hearing
Assist System
(optional)
Personal Monitor
System (optional)
CD
Player
Wireless Mic
System
Audio
Mixer
3
5
4
7
6
OR
Fiber Box
(outdoor)
Wall Plate
(indoor)
