Fujitsu Siemens Computers PRIMERGY BX, Description

Page: 68 / 674

Main Menu Web-Based Management Interface
Lan Switch and Router Blade
68
The pre-configured users, admin and guest, are assigned to a pre-configured list named
defaultList, which you may not delete. All newly created users are also assigned to the
defaultList until you specifically assign them to a different list.
A user that does not have an account configured on the switch is termed the 'default' or
'non-configured' user. If you assign the 'non-configured user' to a login list that specifies
authentication via the RADIUS server, you will not need to create an account for all users on
each switch. However, by default the 'non-configured user' is assigned to 'defaultList', which by
default uses local authentication.
Selection Criteria
User
- Select the user you want to assign to a login list. Note that you must always
associate the admin user with the default list. This forces the admin user to always be
authenticated locally to prevent full lockout from switch configuration. If you assign a user
to a login list that requires remote authentication, the user's access to the switch from all
CLI, web, and telnet sessions will be blocked until the authentication is complete. Refer to
the discussion of maximum delay in the RADIUS configuration help.
Configurable Data
Authentication List
- Select the authentication login list you want to assign to the user for
system login.
Command Buttons
Submit
- Sends the updated screen to the switch and causes the changes to take effect
on the switch. These changes will not be retained across a power cycle unless you
perform a save.
Refresh
- Updates the information on the page.
6.2.1.4 Defining Forwarding Database
6.2.1.4.1. Configuring MAC Table aging interval time Page
Use this panel to set the Address Ageing Timeout for the forwarding database.
Configurable Data
Address Ageing Timeout (seconds)
- The forwarding database contains static entries,
which are never aged out, and dynamically learned entries, which are removed if they are
not updated within a given time. You specify that time by entering a value for the Address
Ageing Timeout. You may enter any number of seconds between 10 and 1000000. IEEE