Fujitsu Siemens Computers PRIMERGY BX, Description

Page: 508 / 674

Differentiated Service Command Command Reference
Lan Switch and Router Blade
508
To specify the match condition as a numeric value, one layer 4 port number is required. The
port number is an integer from 0 to 65535.
To specify the match condition as a range, two layer 4 port numbers are required and together
they specify a contiguous port range. Each port number is an integer from 0 to 65535, but with
the added requirement that the second number be equal to or greater than the first.
Default
None
Command Mode
Class-Map Config
7.15.3
Policy Commands
The 'policy' command set is used in DiffServ to define:
Traffic Conditioning
Specify traffic conditioning actions (policing, marking, shaping) to
apply to traffic classes
Service Provisioning
Specify bandwidth and queue depth management requirements of
service levels (EF, AF, etc.)
The policy commands are used to associate a traffic class, which was defined by the class
command set, with one or more QoS policy attributes. This association is then assigned to an
interface in a particular direction to form a service. The user specifies the policy name when the
policy is created.
The DiffServ CLI does not necessarily require that users associate only one traffic class to
one policy. In fact, multiple traffic classes can be associated with a single policy, each defining
a particular treatment for packets that match the class definition. When a packet satisfies the
conditions of more than one class, preference is based on the order in which the classes were
added to the policy, with the foremost class taking highest precedence.
This set of commands consists of policy creation/deletion, class addition/removal, and
individual policy attributes. Note that the only way to remove an individual policy attribute from
a class instance within a policy is to remove the class instance and re-add it to the policy. The
values associated with an existing policy attribute can be changed without removing the class
instance.
The CLI command root is
policy-map
.
7.15.3.1 assign-queue
This command modifies the queue id to which the associated traffic stream is assigned. The
queueid is an integer from 0 to n-1, where n is the number of egress queues supported by the