Fujitsu Siemens Computers PRIMERGY BX, Description

Page: 286 / 674

CLI Mode-based Topology Command Reference
Lan Switch and Router Blade
286
7.2 CLI Mode-based Topology
Parameters
Parameters are order dependent.
The text in bold italics should be replaced with a name or number. To use spaces as part of a
name parameter, enclose it in double quotes like this: "System Name with Spaces".
Parameters may be mandatory values, optional values, choices, or a combination.
– <parameter>. The <> angle brackets indicate that a mandatory parameter must be
entered in place of the brackets and text inside them.
– [parameter]. The [] square brackets indicate that an optional parameter may be entered
in place of the brackets and text inside them.
– choice1 | choice2. The | indicates that only one of the parameters should be entered.
The {} curly braces indicate that a parameter must be chosen from
the list of choices.
Values
ipaddr
This parameter is a valid IP address, made up of four decimal bytes ranging from 0 to
255. The default for all IP parameters consists of zeros (that is, 0.0.0.0). The interface IP
address of 0.0.0.0 is invalid.
macaddr
The MAC address format is six hexadecimal numbers separated by colons, for
example 00:06:29:32:81:40.
areaid
Area IDs may be entered in dotted-decimal notation (for example, 0.0.0.1). An area ID
of 0.0.0.0 is reserved for the backbone. Area IDs have the same form as IP addresses, but are
distinct from IP addresses. The IP network number of the sub-netted network may be used for
the area ID.
routerid
The value of <router id> must be entered in 4-digit dotted-decimal notation (for
example, 0.0.0.1). A router ID of 0.0.0.0 is invalid.
slot/port
This parameter denotes a valid slot number, and a valid port number. For example,
0/1 represents slot number 0 and port number 1. The <slot/port> field is composed of a valid
slot number and a valid port number separated by a forward slash (/).
logical slot/port
This parameter denotes logical slot number, and logical port number
assigned. This is applicable in the case of a port-channel (LAG). The operator can use the
logical logical slot number, and the logical port number to configure the port-channel.
Conventions
Network addresses are used to define a link to a remote host, workstation, or network.
Network addresses are shown using the following syntax: