Fujitsu Siemens Computers PRIMERGY BX, Description

Page: 504 / 674

Differentiated Service Command Command Reference
Lan Switch and Router Blade
504
<ipaddr>
specifies an IP address.
<
ipmask>
specifies an IP address bit mask; note that although similar to a standard subnet
mask, this bit mask need not be contiguous.
Default
None
Command Mode
Class-Map Config
7.15.2.8 match dstl4port
This command adds to the specified class definition a match condition based on the
destination layer 4 port of a packet using a single keyword or numeric notation or a numeric
range notation.
Syntax
match dstl4port {<portkey> | <0-65535>}
To specify the match condition as a single keyword, the value for <
portkey>
is one of the
supported port name keywords. The currently supported <
portkey>
values are:
domain, echo,
ftp, ftpdata, http, smtp, snmp, telnet, tftp, www
. Each of these translates into its equivalent
port number, which is used as both the start and end of a port range.
To specify the match condition using a numeric notation, one layer 4 port number is required.
The port number is an integer from 0 to 65535.
To specify the match condition using a numeric range notation, two layer 4 port numbers are
required and together they specify a contiguous port range. Each port number is an integer
from 0 to 65535, but with the added requirement that the second number be equal to or greater
than the first.
Default
None
Command Mode
Class-Map Config
7.15.2.9 match ip dscp
This command adds to the specified class definition a match condition based on the value of
the IP DiffServ Code Point (DSCP) field in a packet, which is defined as the high-order six bits
of the Service Type octet in the IP header (the low-order two bits are not checked).