Fujitsu Siemens Computers PRIMERGY BX, Description

Page: 383 / 674

Management Commands Command Reference
Lan Switch and Router Blade
383
Default Setting
None
Command Mode
Privileged Exec
Display Message
SNMP Community Name:
The community string to which this entry grants access. A valid
entry is a case-sensitive alphanumeric string of up to 16 characters. Each row of this table
must contain a unique community name.
Client IP Address:
An IP address (or portion thereof) from which this device will accept
SNMP packets with the associated community. The requesting entity's IP address is ANDed
with the Subnet Mask before being compared to the IP Address. Note: that if the Subnet
Mask is set to 0.0.0.0, an IP Address of 0.0.0.0 matches all IP addresses. The default value
is 0.0.0.0
Client IP Mask:
A mask to be ANDed with the requesting entity's IP address before
comparison with IP Address. If the result matches with the IP Address then the address is an
authenticated IP address. For example, if the IP Address = 9.47.128.0 and the
corresponding Subnet Mask = 255.255.255.0, a range of incoming IP addresses would
match. That is, the incoming IP Address could equal 9.47.128.0 - 9.47.128.255. The default
value is 0.0.0.0.
Access Mode:
The access level for this community string.
Status:
The status of this community access entry.
7.5.4.2 show trapflags
This command displays trap conditions. Configure which traps the switch should generate by
enabling or disabling the trap condition. If a trap condition is enabled and the condition is
detected, the switch's SNMP agent sends the trap to all enabled trap receivers. The switch
does not have to be reset to implement the changes. Cold and warm start traps are always
generated and cannot be disabled.
Syntax
show trapflags
Default Setting
None
Command Mode
Privileged Exec
Display Message
Authentication Flag:
May be enabled or disabled. The factory default is enabled. Indicates
whether authentication failure traps will be sent.
Link Up/Down Flag:
May be enabled or disabled. The factory default is enabled. Indicates
whether link status traps will be sent.