Fujitsu Siemens Computers PRIMERGY BX, Description

Page: 392 / 674

Management Commands Command Reference
Lan Switch and Router Blade
392
show snmptrap
Default Setting
None
Command Mode
Privileged Exec
Display Message
SNMP Trap Name:
The community string of the SNMP trap packet sent to the trap manager.
This may be up to 16 alphanumeric characters. This string is case sensitive.
IP Address:
The IP address to receive SNMP traps from this device. Enter 4 numbers
between 0 and 255 separated by periods.
SNMP Version:
The trap version to be used by the receiver.
SNMP v1 –
Uses SNMP v1 to send traps to the receiver
SNMP v2 –
Uses SNMP v2 to send traps to the receiver
Status:
A pull down menu that indicates the receiver's status (enabled or disabled) and
allows the administrator/user to perform actions on this user entry:
Enable:
send traps to the receiver
Disable:
do not send traps to the receiver.
Delete:
remove the table entry.
7.5.5.2 snmp trap link-status
This command enables link status traps by interface.
Note:
This command is valid only when the Link Up/Down Flag is enabled. See ‘snmpserver
enable traps linkmode’ command.
Syntax
snmp trap link-status
no snmp trap link-status
no -
This command disables link status traps by interface.
Note:
This command is valid only when the Link Up/Down Flag is enabled. (See
‘snmpserver enable traps linkmode’ command.)
Default Setting
Disabled
Command Mode
Interface Config