Fujitsu Siemens Computers PRIMERGY BX, Description

Page: 420 / 674

Spanning Tree Commands Command Reference
Lan Switch and Router Blade
420
This command sets the Path Cost or Port Priority for this port within the multiple spanning tree
instance or in the common and internal spanning tree. If the <0-4094> parameter corresponds
to an existing multiple spanning tree instance, then the configurations are done for that multiple
spanning tree instance. If however 0 (defined as the default CIST ID) is passed as the
<0-4094>, then the configurations are performed for the common and internal spanning tree
instance.
If the ‘port-priority’ token is specified, this command sets the priority for this port within a
specific multiple spanning tree instance or the common and internal spanning tree instance,
depending on the <0-4094> parameter. The port-priority value is a number in the range of 0 to
240 in increments of 16.
Syntax
spanning-tree mst <0-4094> port-priority <0-240>
no spanning-tree mst <0-4094> port-priority
<0-4094> -
multiple spanning tree instance ID.
no -
This command sets the Path Cost or Port Priority for this port within the multiple
spanning tree instance or in the common and internal spanning tree to the respective
default values. If the <0-4094> parameter corresponds to an existing multiple spanning
tree instance, then the configurations are done for that multiple spanning tree instance. If
however, 0 (defined as the default CIST ID) is passed as the <0-4094>, then the
configurations are performed for the common and internal spanning tree instance.
If the ‘port-priority’ token is specified, this command sets the priority for this port within a
specific multiple spanning tree instance or the common and internal spanning tree
instance, depending on the <0-4094> parameter, to the default value, that is, 128.
Default Setting
port-priorty : 128
Command Mode
Interface Config
7.6.2.10 spanning-tree port mode
This command sets the Administrative Switch Port State for this port to enabled.
Syntax