Fuji Electric Frenic lift, Reference Manual

Page: 241 / 254

Page
No.
Category Code Details
3
Output status FWD Rotating forward
REV Rotating reverse
EXT Inverter applies DC voltage to the motor
INT Inverter stops output
Ramp status Acc During acceleration
Dec During deceleration
Const During constant speed
<Blank> Stopped
Motor type IM Induction motor (asynchronous motor)
PMSM Permanent magnet synchronous motor
Selected control mode PG-IM Vector control with PG for IM
PG-PM Vector control with PG for PMSM
TV Torque vector (open loop) control for IM
Running status PG/Hz : Enable vector control
TrqLimit : During torque limitation
LowVolt : During low supply voltage
4
Operational status FAR : Frequency attained
FDT : Frequency detection
RDY : Ready to run
FAN : Cooling fan operating
TRY : Trying automatic resetting alarm
OH : Overheat early warning
LIFE : Lifetime warning
ID : Current detection
ID2 : Current detection 2
5
Reference torque TRQC Value [%] based on the motor rated torque being at 100%.
Reference torque current TRQI Value [%] based on the motor rated current being at 100%.
Reference torque bias TRQB Value [%] based on the motor rated torque being at 100%.
Electronic thermal for motor OLM Value [%] based on the electronic thermal overload
protection being at 100%.
Detected motor temperature NTC Detected motor temperature [
℃
]
6 CAN status
CAN Sta Operational status
CAN Bus Error status
CAN STM State machine status
7, 8
Acceleration/Deceleration
distance calculation
Page 7: Acceleration distance
Page 8: Deceleration distance
SpInit Initial speed (before acceleration/deceleration) [mm/s]
SpTrgt Target speed (after acceleration/deceleration) [mm/s]
Dist. Calculated distance which takes during acc/dec [mm]
Acc Maximum acceleration rate [mm/s
2
]
Jerk1 1
st
jerk [mm/s
3
]
Jerk2 2
nd
jerk [mm/s
3
]
*1: In vector control with PG, this item shows the reference torque.
3-20