Fuji Electric Frenic lift, Reference Manual

Page: 214 / 254

2.3 Overview of Function Code
C
hap.
2
FUN
CT
IO
N
C
O
D
E
S
L198 Operation setting switch 1
Set L198 bits according to inverter operation.
Bit
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Function
Short
detection
cancel
Ground
fault
detection
cancel
- - - -
Masked
parameters
depending
on set
control
mode
Carrier
frequency
fixed
Data=0 Enable Enable - - - - Disable Disable
Data=1 Cancel Cancel - - - - Enable Enable
Default 0 0 0 0 0 0 0 0
■
Carrier frequency fixed
(Bit 0)
It is possible to fix the carrier frequency to 16 kHz for the whole speed range in order to reduce
driving noise.
 Refer to the description of function code F26.
■
Masked parameters depending on set control mode
(Bit 1)
It is available to mask unused function codes according to each control mode.
■
Ground fault detection cancel
(Bit 6)
■
Short detection cancel (Bit 7)
Normally it is not necessary to change these bits.
L201 Pulse output (OPC-PR/PS/PSH) (AB pulse output rate)
L202 Pulse output (OPC-PR/PS/PSH) (AB pulse output order)
L203 Pulse output (OPC-PR/PS/PSH) (Z pulse output)
L205 Pulse output (OPC-PR/PS/PSH) (AB pulse output hysteresis)
L209 Pulse output (OPC-PR/PS/PSH) (Number of ST bits)

For details, refer to the instruction manual of the corresponding option card.
2-201