Fuji Electric Frenic lift, Reference Manual

Page: 129 / 254

■
Inputs 1 and 2 (U02, U03, U07, U08, etc.)(Digital)
The following digital signals are available as input signals. Value in ( ) is in negative logic.
Data Selectable Signals
0000 (1000)
General-purpose output signals Same as the ones specified by E20, e.g., “RUN”
(Inverter running), FAR (Frequency (speed) arrival signal), “FDT” (Frequency
(speed) detected), “LU” (Undervoltage detected (Inverter stopped))
Note: 27 (Universal DO) is not available.
Note: Customizable logic output signals from 141 (1141) to 150 (1150) cannot be
selected.
to
0129 (1129)
2001 (3001)
Output of step 1 “SO001”
to
to
2200 (3200)
Output of step 200 “SO200”
4001 (5001)
Terminal X1 input signal “X1”
4002 (5002)
Terminal X2 input signal “X2”
4003 (5003)
Terminal X3 input signal “X3”
4004 (5004)
Terminal X4 input signal “X4”
4005 (5005)
Terminal X5 input signal “X5”
4006(5006)
Terminal X6 input signal “X6”
4007(5007)
Terminal X7 input signal “X7”
4008(5008)
Terminal X8 input signal “X8”
4010 (5010)
Terminal FWD input signal FWD
4011 (5011)
Terminal REV input signal REV
6000 (7000)
Final RUN command “FL_RUN” (ON when a run command is given)
6001 (7001)
Final FWD run command “FL_FWD” (ON when a run forward command is
given)
6002 (7002)
Final REV run command “FL_REV” (ON when a run reverse command is given)
6007 (7007)
Alarm factor presence “ALM_ACT” (ON when there is no alarm factor)
2-116