Fuji Electric Frenic lift, Reference Manual

Page: 86 / 254

2.3 Overview of Function Code
C
hap.
2
FUN
CT
IO
N
C
O
D
E
S
E48 LED Monitor (Speed monitor item)
E43 (LED Monitor, Item selection)
E48 specifies speed monitor item to be displayed on the LED monitor when the speed monitor is
selected in E43.
 For details, refer to the description of function code E43.
E52 Keypad (Menu display mode)
E52 specifies the menus to be displayed on the standard keypad (TP-E1U). E52 provides a choice of
three menu display modes as listed below:
E52 data Menu display mode Menus to be displayed
0
Function code data editing mode Menus #0, #1 and #7
1
Function code data check mode Menus #2 and #7
2
Full-menu mode Menus #0 through #7
There are eight menus as shown in the table below:
Menu #
LED monitor
shows:
Function Display content
0 *.fnc
Quick setup Quick setup function code
1
!.f__
Data setting F to o F to K group function code
2
".rep
Data check Modified function code
3
#.ope
Operation monitor Operation status indication
4 $.i_o
I/O check DIO, AIO status indication
5
%.che
Maintenance Maintenance information indication
6
&.al
Alarm information Alarm information indication
7
' cpy
Data copy Data copy function
E59 Terminal [V2] function selection (C1 function//V2 function)
Specifies whether terminal [V2] is used with current input +4 to +20 mA or voltage input 0 to +10 V.
In addition, switch SW4 on the interface board must be switched.
E59 data Input form Switch SW4
0
Current input: 4 to 20 mA (C1 function)
C1
1
Voltage input: 0 to 10 V (V2 function)
V2

For details about SW4, refer to the Instruction manual.
Failure to set correctly SW4 switch as explained above may cause a wrong analog input value, possibly
leading to unexpected operation of the inverter.
Injuries may occur.
Failure may occur.
2-73