Foma N903i, Manual

Page: 79 / 580

77
Continued on next page
Voice/Videophone Calls
2
Press
r
or
d
to resume the call
When“Answer setting” is set to “Any key answer”, you can also answer the call by pressing
0
to
9
,
w
,
t
,
b
,
o
,
a
(
R
) or the assist key. Furthermore, pressing
s
(MEMO/CHECK),
q
or
p
also enables
you to answer the call.
For videophone calls → p.72
<Holding>
Putting Ongoing Calls on Hold
1
During a call
X
t
The other party hears the on-hold tone.
■
To end the held call
X
y
■
If the held party hangs up
The call ends.
2
Press
t
,
r
or
d
to resume the call
<Set hold tone>
Setting the Hold Tone
Set the message given to the other party when you put a voice or videophone call on answer hold or
put an ongoing call on hold.
1
i
X
“Settings”
X
“Talk”
X
“Set hold tone”
X
Select any item
* ： Not displayed if no Voice Announce message has been recorded.
NOTE
e
Call charges apply to a caller while he or she is waiting for you to answer.
e
If “Phone” or “Videophone” in “Ring volume” is set to “Silent” or a FOMA terminal is in Manner mode, the FOMA
terminal does not make the three short beeps when you activate answer hold. However, the beeps do sound when
“Manner mode set” is set to “Original” in which “Phone vol.” is not “Silent”.
e
If you have subscribed to the “Voice Mail” or “Call Forwarding” service, selecting “Voice Mail” or “Call Forwarding”
from the function menu when a call arrives either forwards the call to the Voice Mail service center or forwarding
number.
e
If you fold a FOMA terminal while a call is on answer hold, the image display shows the call is held.
NOTE
e
Call charges still apply while a call is on hold.
e
Use “Set hold tone” to select the tone that sounds while a call is on hold.
e
A hold tone also sounds on your FOMA terminal while a call is on hold. However, the hold tone does not sound
when “Phone” in “Ring volume” is set to “Silent” or Manner mode is set. (The tone sounds if you have selected
“Original” in “Manner mode set” in which the “Phone vol.” setting is not “Silent”.)
Default setting On hold tone: Tone 1 Holding tone: Melody 1
On hold tone Sets the message given when an incoming call is put on hold.
Tone 1 The following message is given in Japanese:
“I can’t answer the phone just now. Please wait for a few minutes or call again later.”
Tone 2 The following message is given in Japanese:
“I can’t answer the phone just now. Please call again later.”
Voice announce 1
*
Plays the message recorded using “Voice announce”.
“Recording and Playing Alarm Tones and On Hold Tones”
→ p.406
Voice announce 2
*
Holding tone Sets the hold tone given during a call.
Melody 1 “Fur Elise” is played.
Melody 2 “Mary Had A Little Lamb” is played.
Melody 3 “Symphony No.25 in G minor” is played.
Voice announce 1
*
Plays the message recorded using “Voice announce”.
“Recording and Playing Alarm Tones and On Hold Tones”
→ p.406
Voice announce 2
*
１ｍ３０ｓ
ＩｃｈｉｒｏＤｏｃｏｍｏ
［Ｏｎ ｈｏｌｄ］