Foma N903i, Manual

Page: 58 / 580

56
Voice/Videophone Calls
d
If you entered a wrong phone number
■
To insert a number
Press
v
to move the cursor to the number on the left of the insert position and enter the number.
■
To delete a number
Press
v
to move the cursor to the number to delete and press
t
.
Pressing
t
for 1 second or longer deletes the highlighted number and all numbers on the left side of
the highlighted number.
■ To reenter a number
Move the cursor to the beginning or end of the number and press
t
for 1 second or longer to return to
the standby screen.
d
If a videophone call is not connected
If a videophone call is not connected, a message giving the reason for the connection failure appears.
However, in some circumstances, an explanatory message may not be displayed. Also, depending on
the type of phone used by the callee and the possible lack of a network service subscription, the
reason given may not accurately reflect the callee’s actual status.
*
：
This message may also appear during packet communication depending on the type of other party’s terminal.
FrontCamera
Rev. Sets the type of camera image to display on your FOMA terminal during a call.
ON
(default)
Displayed in mirror image.
OFF Displayed in normal image.
Call time disp.
(default: ON)
Sets whether to display the call time during a call.
Own number Displays your phone number during a videophone call.
Send DTMF tone,
DTMF tone OFF Sets/cancels push signal transmission mode while using Chara-den.
Except for Chara-den, videophone calls are always in push signal transmission mode.
Change to voice “Changing a call from videophone to voice” → p.58
Loc. notification “Selecting a party to notify of location information”
→
p.316
Message Reason
Check number then redial The dialed phone number is currently not used.
Busy
*
The line is busy.
Busy with packet transmission Packet communication is in progress on the callee.
Out of service area/power off The callee’s phone is out of service or the power is turned off.
Set caller ID to ON The call is connected without showing your caller ID (when dialing visualnet).
Your call is being forwarded The call is being forwarded (into a videophone call if the forwarding
party has a videophone that complies with 3G-324M).
Redial using voice call The forwarded party is non-videophone-terminal.
Please activate caller ID before dialing again The Caller ID Request service is set on the callee.
At the user’s request, your call can not be connected The Nuisance Call Blocking service is set on the callee.
Upper limit has been exceeded Connection failed The upper limit set for a Limit billing plan (Type Limit and Family
Wide Limit) is exceeded.
Connection failed Set “Caller ID Notification” to “ON” and then try again.
a This message may also be displayed in other situations.
Please make your call from the i-mode web page You attempted to make a videophone call to watch V-live without
browsing the i-mode official site.
NOTE
e
If you make a videophone call to an emergency number (110, 119 or 118) from a FOMA terminal, the call is
automatically changed to a voice call.
e If you make a videophone call to a phone that does not support videophone call, or if the callee’s phone supports
videophone call but is out of signal range or switched off, no connection can be established. If you called a phone
that does not support videophone call and “Auto redial as voice” (p.86) is set to “ON”, the call is cut off by the called
party before the videophone connection is established and is then automatically redialed as a voice call. However,
this operation may not be carried out if you dial a wrong number or if you call an ISDN synchronous 64K, PIAFS
access point or an ISDN videophone that does not conform to the 3G-324M standard (as of November 2006). Note
that the call charge may apply in some cases.