Foma N903i, Manual

Page: 47 / 580

45
Getting Started
Charging with the desktop holder
1
Plug the AC adapter connector horizontally into the terminal on the
rear of the desktop holder in the direction as shown above
2
Plug the AC adapter into a power outlet
3
Place a FOMA terminal securely in the desktop holder as shown
above
4
After charging is completed, hold down the
desktop holder and lift the FOMA terminal up
in the direction of the arrow
Standard charging time
Approx. 120 min.
NOTE
e
Set a FOMA terminal securely in the desktop holder. Take care not to trap the strap.
e
The charge lamp lights red during charging. When the charge lamp turns off, the FOMA terminal is fully charged. If
the FOMA terminal is turned on, “ ” flashes during charging and “ ” lights when charging ends.
e
If the FOMA terminal is turned on, the terminal emits the “Charge sound” when charging starts or ends. However,
while “Manner mode” or “Public mode (Driving mode)” is set or when “Charge sound” is set to “OFF”, the “Charge
sound” does not sound.
e
The AC adapter 01 is only suitable for use with 100 V AC power supplies.
e The battery pack cannot be charged separately. Always charge the battery pack while it is inserted in a FOMA
terminal.
e
If the battery runs out or the FOMA terminal is turned off with full data in the phonebook, etc., the battery charge
lamp may not light right away, but charging has already started.
e The DC adapter must be used only for vehicles with a negative ground DC 12V or 24V. Never use it in positive-
grounded vehicles.
e
The DC adapter uses a 2A fuse. If the fuse (2A) blows and you need to replace it, always use a fuse with the same
specifications. Fuses (2A) are consumable items and replacement fuses can be purchased at your local car
accessory shop, etc.
100 V AC power outlet
Desktop Holder N12
FOMA AC Adapter 01
Plug
Connector