Extreme Networks BlackDiamond 10808, Hardware Installation Manual

Page: 298 / 424

Summit Option Cards
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
298
The Summit XGM2-2xn option card is compatible with the following 10-gigabit XENPAK modules:
●
SR XENPAK module, operating in the 850 nm range
●
LR XENPAK module, operating in the 1310 nm range
●
ER XENPAK module, operating in the 1550 nm range
●
ZR XENPAK module, operating in the 1550 nm range
●
LX-4 XENPAK module, operating in the 1269-1355 nm range
●
LW XENPAK module, operating in the 1310 nm range
Figure 205 shows the Summit XGM2-2xn option card.
Figure 205: Summit XGM2-2xn option card
NOTE
Refer to “XENPAK Interfaces” on page 354 for more information about XENPAK modules.
Standards-based CX-4 XENPAKs are also recognized by ExtremeXOS; contact your CX-4 module vendor to obtain
these.
Installing the Summit XGM2-2xn Option Card
CAUTION
The Summit XGM2-2xn option card is not hot-swappable. Disconnect power to the switch before installing or
removing the Summit XGM2-2xn option card. After the Summit XGM2-2xn option card is installed in a compatible
switch, XENPAK modules may be hot-swapped into and out of the option card. Use only XENPAK modules approved
by Extreme Networks.
CAUTION
Be sure that the option slot always has either an installed Summit option card or a faceplate over the opening. An
open slot could divert air from the switch and cause overheating.
SH_010