Installing a BlackDiamond 10808 Series Module
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
179
To disconnect a cable from a 10G4Ca module:
1
Holding the cable connector with one hand, press it against the module front panel as you use the
other hand to pull back evenly on the latch (
Figure 109
).
Figure 109: Disconnecting a cable from a 10G4Ca port
2
Make sure the latch is pulled into the fully disengaged position.
3
Pull the cable connector straight off the port connector.
Installing a BlackDiamond 10808 Series Module
BlackDiamond 10808 series modules are hot-swappable. You can insert a BlackDiamond 10808 series
MSM or I/O module at any time, without causing disruption of network services. Complete the action
of inserting a BlackDiamond 10808 series module in a reasonable time frame. Be sure to insert the
module completely to avoid partial connection of backplane connectors.
The BlackDiamond 10808 switch comes with eight blank front panels already installed. Use a blank
front panel to fill slots not occupied by I/O modules or switch management modules. For information
about how to install a blank front panel, see
“BlackDiamond Series Blank Front Panels” on page 185
.
You need the following tools and equipment to install a module
●
ESD-preventive wrist strap (provided)
●
# 2 Phillips screwdriver
●
Appropriate type of cable for the module if you are installing an I/O module
BD_158A
Summary of Contents for BlackDiamond 10808
