Extreme Networks BlackDiamond 10808, Hardware Installation Manual

Page: 350 / 424

Extreme Networks Optics
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
350
SR XFP Module
The SR XFP module requires the software versions listed in Table 62 .
Table 63 lists specifications for the SR XFP module.
Table 63: SR XFP module specifications
Installing an XFP Module
This section describes how to install and remove an XFP module ( Figure 239 ). You can install or remove
an XFP module from your Extreme Networks switch without powering off the system.
Table 62: SR XFP module software requirements
Switch Model Required Software
BlackDiamond Switches
BlackDiamond 8800 series ExtremeXOS 11.6.1.9 or later
Summit Switches
Summit X450a series ExtremeXOS 11.5.1 or later
Summit X450e series ExtremeXOS 11.5.1 or later
Parameter Minimum Maximum
Average launch power -7.3 dBm –1.3 dBm
Channel insertion loss:
62.5
μ
m (160/200 MHz*km)
62.5
μ
m (200 MHz*km)
50
μ
m (400 MHz*km)
50
μ
m (500 MHz*km)
50
μ
m (2000 MHz*km)
1.6 dB
1.6 dB
1.7 dB
1.8 dB
2.6 dB
Wavelength range 840 nm 860 nm
Operating distance range
(depends on type and modal bandwidth)
62.5
μ
m MMF (160 MHz*km)
62.5
μ
m MMF (200 MHz*km)
50
μ
m MMF (400 MHz*km)
50
μ
m MMF (500 MHz*km)
50
μ
m MMF (2000 MHz*km)
26 m
33 m
66 m
82 m
300 m
Maximum receiver sensitivity in OMA -11.1 dBm