Extreme Networks BlackDiamond 10808, Hardware Installation Manual

Page: 64 / 424

BlackDiamond 8800 Modules
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
64
The 10G4Ca I/O module has the following LEDs:
●
Module status
●
Module diagnostics
●
Port status
For information about the LEDs and their activity on the 10G4Ca I/O module, see “I/O Module LEDs”
on page 66 .
BlackDiamond 8800 E-Series I/O Modules
The BlackDiamond 8800 e-series of I/O modules consists of the following:
●
G48Te I/O Module on page 64
●
G48Pe I/O Module on page 65
CAUTION
ExtremeXOS software builds earlier than version 11.5.0 do not support G48Te or G48Pe I/O modules. If you attempt
to install one of these I/O modules before upgrading the software on your MSM-G8X, the module will not be
recognized by the software and it will not power up. The following error messages are similar to the messages that
may be displayed on the console or in the log. (Samples represent an unrecognized module in slot 2.)
●
Console: ERROR: Unknown cardtype in slot 2 - please program the eeprom
●
Log: <Error: HAL.Card.Error> MSM-A: Unable to read cardtype for slot 2
G48Te I/O Module
Figure 28 shows the G48Te I/O module.
Figure 28: G48Te I/O module
The G48Te I/O module has 48 autosensing 10/100/1000BASE-T ports that use standard RJ-45
connectors. When an 8800 series switch is running in dual-MSM mode, this module will be
oversubscribed 2:1. When the switch is running a single MSM, this module will be oversubscribed 4:1.
The default configuration of the G48Te I/O module is as follows. All ports:
●
Are added to the default VLAN as untagged
●
Inherit the properties of the default VLAN (for example, protocol type and VLANid)
●
Operate in autonegotiation mode
Module status LEDs
ASP047
10/100/1000BASE-T
ports