Extreme Networks BlackDiamond 10808, Hardware Installation Manual

Page: 309 / 424

EPS-160 External Power Module (with EPS-T)
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
309
EPS-160 External Power Module (with EPS-T)
The Extreme Networks EPS-160 External Power Module can be added as a redundant power supply to
the Summit X450-24t, X450-24x, X250e-24t, or X250e-48t switch. The entire EPS system consists of a tray
(EPS-T) that holds one or two EPS-160 power supplies. Each EPS-160 power supply provides one-to-one
redundancy to an attached switch.
The EPS-160 power supply is installed in an EPS-T rack-mountable chassis. The EPS-T chassis can be
ordered with one or two EPS-160 power supplies already installed. You can also order an additional
power supply from your Extreme Networks reseller.
NOTE
Each individual EPS-160 power supply is shipped with an AC cord for use in North America and a special redundant
power supply cord.
Table 39 shows the wire-to-pin connections for the connector on the rear panel of the EPS-160 power
supply.
Figure 217 shows the redundant power cord connector.
Figure 217: Redundant power cord connector
Table 39: Pinouts for the redundant power supply connector
Pin Number Wire Label
1 NC
2 GND
3 GND
4 GND
5 GND
6 +12 V
7 +12 V
8 RS+
9 GND
10 INT PG
11 EXT_CON
12 EXT_PG
13 +5 V
14 +12 V
ES4K027