Ericsson ECN330, User Manual

Page: 97 / 1226

Configuring the ECN330-switch
91
1553-KDU 137 365 Uen D 2006-06-16
If downloading to a new file name using “tftp to startup-config” or “tftp to file,” the
file is automatically set as the start-up configuration file. To use the new settings,
reboot the system using the System/Reset menu. Or select any configuration file
as the start-up configuration by using the System/File Management/Set Start-
Up page.
Figure 23 Setting the Startup Configuration Settings
CLI – Enter the IP address of the TFTP server, specify the source file on the
server, set the startup file name on the ECN330-switch, and then restart the
ECN330-switch.
If the startup configuration file is downloaded under a new file name, this file can
be set as the startup file at a later time before restarting the ECN330-switch.
Console#copy tftp startup-config
TFTP server ip address: 192.168.1.19
Source configuration file name: config-1
Startup configuration file name [] : startup
\Write to FLASH Programming.
-Write to FLASH finish.
Success.
Console#reload
Console#config
Console(config)#boot system config: startup
Console(config)#exit
Console#reload