Ericsson ECN330, User Manual

Page: 747 / 1226

Command Line Interface
741
1553-KDU 137 365 Uen D 2006-06-16
• Auto-negotiation cannot be disabled for Gigabit Ethernet ports, which
only operate at 1000full (1 Gbps full-duplex).
• When auto-negotiation is enabled, the ECN330-switch negotiates the
best settings for a link based on the available capabilities advertised by
the interface. An interface’s advertised capabilities can be configured
using the
capabilities
command. When auto-negotiation is
disabled for Fast Ethernet ports, link attributes must be manually
specified using the
speed-duplex
and
flowcontrol
commands.
• If auto-negotiation is disabled for Fast Ethernet ports, auto-MDI/MDI-X
pin signal configuration will also be disabled for the RJ45 ports.
Example
The following example configures port 11 to use auto-negotiation.
Related Commands
negotiation
(section 7.9.4 on page 740)
speed-duplex
(section 7.9.3 on page 739)
7.9.5 capabilities
This command advertises the port capabilities of a given interface during auto-
negotiation. Use the
no
form with parameters to remove an advertised
capability, or the
no
form without parameters to restore the default values.
Syntax
[no] capabilities {1000full | 100full | 100half | 10full
| 10half | flowcontrol | symmetric}
•
1000full
- Supports 1000 Mbps full-duplex operation
•
100full
- Supports 100 Mbps full-duplex operation
•
100half
- Supports 100 Mbps half-duplex operation
Console(config)#interface ethernet 1/11
Console(config-if)#negotiation
Console(config-if)#