Ericsson ECN330, User Manual

Page: 49 / 1226

Initial Configuration
43
1553-KDU 137 365 Uen D 2006-06-16
Before the IP Address can be configured, the following must be known:
• IP address for the ECN330-switch
• Default gateway for the network
• Network mask for this network
To assign an IP address to the ECN330-switch, complete the following steps:
1. At the global configuration mode prompt, type
interface vlan
< vlan-id >
to access the interface-configuration mode. The range for
VLAN IDs is 1-4094 for ECN330 mode, and 1 or 246 for ECN330-switch
mode. To manually configure an address for VLAN 246, type
interface
vlan 246
and press <Enter>.
2. Type
ip address <ip-address> <netmask>
, where
ip-address
is
the ECN330-switch’s IP address and
netmask
is the network mask for the
network. Press <Enter>.
3. Type
exit
to return to the global configuration mode prompt. Press
<Enter>.
4. To set the IP address of the default gateway for the network to which the
ECN330-switch belongs, type
ip default-gateway
<gateway>
, where
gateway
is the IP address of the default gateway. Press <Enter>.
5.3.4.2 Dynamic Configuration
If the
bootp
or
dhcp
option is selected, IP is enabled but does not function until
a BOOTP or DHCP reply has been received. Therefore, the
ip dhcp restart
client
command must be used to start broadcasting service requests.
Requests are sent once every minute until IP configuration information is
obtained from a BOOTP or DHCP server. (BOOTP and DHCP values can
include the IP address, subnet mask, and default gateway.)
Console(config)#interface vlan 246
Console(config-if)#ip address 192.168.1.5 255.255.255.0
Console(config-if)#exit
Console(config)#ip default-gateway 192.168.1.254
Console(config)#