Ericsson ECN330, User Manual

Page: 118 / 1226

Configuring the ECN330-switch
112
1553-KDU 137 365 Uen D 2006-06-16
• Trap Manager Community String – Specifies a valid community string
for the new trap manager entry. Though this string can be set in the Trap
Managers table, it is recommended that this string be defined in the
SNMP Configuration page (for Version 1 or 2c clients), or define a
corresponding “User Name” in the SNMPv3 Users page (for Version 3
clients). (Range: 1-32 characters, case sensitive)
• Trap UDP Port – Specifies the UDP port number used by the trap
manager.
• Trap Version – Indicates if the user is running SNMP v1, v2c, or v3.
(Default: v1)
• Trap Security Level – When trap version 3 is selected, specify one of
the following security levels. (Default: noAuthNoPriv)
• noAuthNoPriv – There is no authentication or encryption used in
SNMP communications.
• AuthNoPriv – SNMP communications use authentication, but the
data is not encrypted (only available for the SNMPv3 security
model).
• AuthPriv – SNMP communications use both authentication and
encryption (only available for the SNMPv3 security model).
• Trap Inform – Notifications are sent as inform messages. Note that this
option is only available for version 2c and 3 hosts. (Default: traps are
used)
• Timeout – The number of seconds to wait for an acknowledgment
before resending an inform message. (Range: 0-2147483647
centiseconds; Default: 1500 centiseconds)
• Retry times – The maximum number of times to resend an inform
message if the recipient does not acknowledge receipt. (Range: 0-
255; Default: 3)
• Enable Authentication Traps – Issues a trap message to specified IP
trap managers whenever authentication of an SNMP request fails.
(Default: Enabled)
• Enable Link-up and Link-down Traps – Issues a trap message
whenever a port link is established or broken. (Default: Enabled)
Note: Enable Authentication Traps and Enable Link-up and Link-down
Traps are legacy notifications and therefore when used for SNMP Version 3