Ericsson ECN330, User Manual

Page: 1029 / 1226

Command Line Interface
1023
1553-KDU 137 365 Uen D 2006-06-16
Address Resolution Protocol (ARP)
This section describes commands used to configure ARP on the ECN330-
switch.
Table 124 Address Resolution Protocol Commands
7.25.6 arp
This command adds a static entry in the Address Resolution Protocol (ARP)
cache. Use the
no
form to remove an entry from the cache.
Syntax
arp < ip-address > < hardware-address >
no arp < ip-address >
•
ip-address
- IP address to map to a specified hardware address.
•
hardware-address
- Hardware address to map to a specified IP
address. (The format for this address is xx-xx-xx-xx-xx-xx.)
Default Setting
No default entries
Command Function Mode Page
arp
Adds a static entry in the ARP cache GC 1023
arp-timeout
Sets the time a dynamic entry remains in the ARP
cache GC 1024
clear arp-
cache
Deletes all dynamic entries from the ARP cache PE 1025
show arp
Displays entries in the ARP cache NE, PE 1026
ip proxy-arp
Enables proxy ARP service VC 1027