Ericsson ECN330, User Manual

Page: 50 / 1226

Initial Configuration
44
1553-KDU 137 365 Uen D 2006-06-16
If the
bootp
or
dhcp
option is saved to the startup-config file (step 6), then the
ECN330-switch will start broadcasting service requests as soon as it is powered
on.
To automatically configure the ECN330-switch by communicating with BOOTP
or DHCP address allocation servers on the network, complete the following
steps:
1. At the global configuration mode prompt, type
interface vlan
<
vlan-id
>
to access the interface-configuration mode. The range for
VLAN IDs is 1-4094 for ECN330 mode, and 1 or 246 for ECN330-switch
mode. To dynamically configure an address for VLAN 246, type
interface
vlan 246
and press <Enter>.
2. At the interface-configuration mode prompt, use one of the following
commands:
• To obtain IP settings through DHCP, type
ip address dhcp
and press
<Enter>.
• To obtain IP settings through BOOTP, type
ip address bootp
and
press <Enter>.
3. Type
exit
to return to the global configuration mode. Press <Enter>.
4. Type
ip dhcp restart client
to begin broadcasting service requests.
Press <Enter>.
5. Wait a few minutes, and then check the IP configuration settings by typing
the
show ip interface
command. Press <Enter>.
6. Save the configuration changes by typing
copy running-config
startup-config
. Type the startup file name when prompted and press
<Enter>.