Ericsson ECN330, User Manual

Page: 1084 / 1226

Command Line Interface
1078
1553-KDU 137 365 Uen D 2006-06-16
Command Usage
Interface cost reflects the port speed. This router uses a default cost of 1 for
all ports. Therefore, if any ports are used at 100 Mbps or greater, the cost
may have to be reset to a value greater than 1.
Example
7.26.36 ip ospf dead-interval
This command sets the interval at which hello packets are not seen before
neighbors declare the router down. Use the
no
form to restore the default value.
Syntax
ip ospf dead-interval <
seconds
>
no ip ospf dead-interval
seconds
- The maximum time that neighbor routers can wait for a hello
packet before declaring the transmitting router down. This interval must
be set to the same value for all routers on the network. (Range: 1-
65535)
Command Mode
Interface Configuration (VLAN)
Default Setting
40, or four times the interval specified by the
ip ospf hello-interval
command.
Console(config)#interface vlan 1
Console(config-if)#ip ospf cost 10
Console(config-if)#