DRESSTA TD-25M EXTRA, Service Manual

Page: 184 / 595

SECTION 7C
TRANSMISSION
Page 66
TD-25M EXTRA DRESSTA
DRIVE TRAIN CONTROL VALVE
23. INSTALLATION
1. Install drive train control valve (4, Fig. 7C.63) into the valve bracket (2) and secure with three
mounting bolts (3).
2. Put the valve bracket (2) with drive train control valve mounted into position, and install the
assembly to the platform with four bolts (1).
3. Install valve console (3, Fig. 7C.61) into platform and secure with bolts (4).
4. Turn on control lever (5) with attached boot and electrical harness. Install two stiffener plates
along with control lever.
5. Reconnect control lever harness (3, Fig. 7C.62).
6. Reconnect all hoses (1) to the drive train control valve (2).
7. Install bracket (2, Fig. 7C.60) with filters (4) to the ROPS bracket and secure with bolts (3).
Reconnect the electrical harness to the filter base.
WARNING! Be sure the area around the machine is clear of personnel and
obstructions as the vehicle may move during these test. If the machine starts to
move, fully depress the decelerator pedal and shift the drive train control lever to
NEUTRAL.
8. Reinstall cover (1, Fig. 7C.61) and secure with bolts (2).
9. Apply parking brake. Start the engine. Move the drive train control lever through all the lever
positions and check connections for leaks.
10. Install access cover (1, Fig. 7C.59) and secure with bolts (2).
11. Reinstall L.H. enclosure (3) on the left hand side and secure with bolts (4).
12. Check the oil level in the rear main frame as described in the OPERATOR”S MANUAL, add oil
if required.