DRESSTA TD-25M EXTRA, Service Manual

Page: 12 / 595

SECTION 1
INTRODUCTION
Page 4
TD-25M EXTRA DRESSTA
SAFETY PRECAUTIONS
Electrical system is 24-volt negative ground.
Each machine is equipped with a booster receptacle that is to be used during the engine start up
with a booster battery. When the use of the booster receptacle socket is impossible in
out-of-normal situations, follow the precautions given below to prevent chances of injury or damage
to electrical circuits.
1. Turn the electrical master switch to the OFF position.
2. Attach one end of jumper cable to the positive terminal of booster battery and other end to the
positive terminal of machine battery.
3. Attach one end of second cable to the negative terminal of booster battery and other end to the
machine's frame away from the battery.
4. To remove cables, reverse above sequence exactly to avoid sparks near the battery.
A frozen battery can explode when the booster cables are attached. NEVER check battery charge
by placing a metal object across the battery posts. The sparks could cause an explosion. Use
a voltmeter or areometer for checking.
Every machine is factory equipped with a safety belt mounted to the operator’s seat.
2. BEFORE STARTING THE ENGINE
Never start the engine indoors unless proper exhaust ventilation is provided to remove deadly
exhaust gases. Once the engine is operating, move the machine outdoors as soon as possible.
Exhaust gases are dangerous and can cause unconscious-ness and death.
Always place the drive train neutral lock lever in locked position and apply the parking brake before
starting the engine.
The operator must be alert, physically fit and free from the influences of alcohol, drugs or
medications that might affect his eyesight, hearing, reactions or judgment.
Observe and know the use of alternate exits from the operator compartment.
Safety must always be the operator's most important concern. He must refuse to operate when he
knows it is unsafe and consult his supervisor when safety is in doubt.
Do not jump onto or of the machine. When mounting or leaving the machine always use two feet
and one hand or one foot and two hands to ensure contact with machine steps, holders or rails.
Do not use controls or hoses as hand holds when climbing on or off the machine. Hoses and
controls can move and do not provide solid support. Movement of the controls may cause
inadvertent and unexpected movement of the machine or its equipment.
Follow all machine-mounted safety signs before starting, operating, maintaining or servicing the
machine.
Be sure the area of the operator's compartment, all mounting steps and grab handles are free of
oil, grease, loose objects, ice and mud to lessen the possibility of slipping. Remove or secure all
maintenance and personal items so they will not interfere with the operator or jam the controls.