DRESSTA TD-25M EXTRA, Service Manual

Page: 247 / 595

STEERING DRIVE
SECTION 7E
Page 35
DRESSTA TD-25M EXTRA
TWO SPEED STEERING VALVE
Linkage and Valves (Refer to Fig. 7E.32)
22. Put the balls (3 and 4) into their seats in the lower steering valve (5).
23. Install new gasket (2) between upper (1) and lower steering valve (5). Install six bolts and
torque them to 52 [Nm].
24. Install lever bracket (9) to the lower steering valve (5).
25. If removed reinstall bearings (14) and lube fitting (15) into brake lever (11).
26. Reinstall brake lever (11) with shaft (10) and links (12) with pins (13) to the lever bracket (9)
and upper steering valve brake spool respectively.
13. INSTALLATION (Refer to Fig. 7E.31)
1. Remove covering from the steering valve opening in the main frame and install steering valve
as follows:
A. Install a new gasket (6, Fig. 7E.32) over studs (8)
B. Thoroughly clean the mating surfaces of the main frame cover and steering valve.
Apply LOCTITE #504 to rear main frame cover in a continuous bead on centerline of
valve mounting holes (refer to Fig. 7E.36).
C. Lower steering valve (6 Fig.7E. 31) onto studs. Secure valve (6) with three nuts (9) and
washers on studs and ten bolts (7 and 8).
Fig. 7E.36. LOCTITE to Rear Cover
1. Stud 2. LOCTITE #504 Gasket Eliminator
2. Reconnect pressure supply hose (13) and two pressure check hoses (5).
3. Reconnect two pilot hoses (12) and two short pilot hoses (2) to the steering valve (6) and drain
hose (10) to the Hi-Lo valve (11).
4. Reconnect clevis with brake control cable to the brake lever (4).
5. Reconnect wiring harnesses (3) to the two solenoids.