Cabletron Systems ELS10-26, Reference Manual

Page: 121 / 170

ELS10-26 MIB
6-9
lxadminStaticPreference {lxadmin 16}
Integer Read-Write
2
The value to assign to ipRouteMetric2, when adding a
statically-defined entry to the IP Routing Table.
lxadminRipPreference {lxadmin 17}
Integer Read-Write
The value to assign to ipRouteMetric2, when adding a RIP-learned
entry to the IP Routing Table.
lxadminRipRouteDiscards {lxadmin 18}
Counter Read-Only
The number of times a route learned via RIP was not added to the
IP Routing Table due to insufficient Routing Table space.
lxadminRebootConfig {lxadmin 19}
Integer Read-Write
The configuration file that will be used when the ELS10-26 reboots.
This parameter is normally set by the ELS10-26 automatically;
however, an NMS may explicitly set it to either no-change (1) or
revert-to-defaults (3). The possible values include:
• no-change (1) – the ELS10-26 will not change its configuration
parameters when it reboots.
• tftp-config (2) – the ELS10-26 will use a file that was sent via
TFTP when it reboots .
• revert-to-defaults (3) – the ELS10-26 will revert to its factory
specified defaults when it reboots .
Setting this parameter to a value of 2 will result in an error
condition.
2.
If a value for ipRouteMetric2 is explicitly provided when an entry is created,
then lxadminStaticPreference will be ignored.