Barco Event Master E2 Series, User Manual

Page: 195 / 584

R5905948 /12 Event Master Devices 195
Image 6-62: Cabling between an E2 Jr. unit and an S3 – 4K Jr. unit
Event Master Configuration
1. Start the Event Master Toolset version 4.1 or higher.
2. Make sure that both units are discovered on the network and that they have different Unit IDs.
3. Drop the first in the GUI.
4. Drop the second unit in the GUI.
You will be presented the option to add as a new system, add as a master, or add as a slave. An S3 – 4K can
be added as a Master or Slave to an E2.
5. Add the second unit as a slave.
6. (Optional) At this point it is suggested that you select and name appropriately each unit so that you can
identify it in your setup.
Connection Control
From the configuration page switch from the detail view to the System view and ensure that the status is good
(green) for all link connections. If any connections is shown as red, please check that the cables were
connected as described in step b and they were fully seated.
Programming
Referring to section “ System Setup ” , page 273, you may now proceed with the configuration and programming
of the E2 linked system having full access to all resources in the system.
Auto Creation
If you choose to auto create your inputs, outputs and MVR outputs they will be created from Unit ID 0 first and
then followed by the ones from Unit ID 1.
Configuration Order
You may proceed with defining your destinations, auxes and assign your layers. It is recommended that you
setup all screen destinations and make layer assignment before you setup the Multiviewer(s).
The Multiviewer and Web App sections of the Event Master Toolset have an additional selection.
You may select whether you are viewing the Master or Slave E2 Multiviewer windows or the Master
or Slave E2 Web App. The selection names correspond to the way you named the units in steps
above.
EM GUI orientation