Barco Event Master E2 Series, User Manual

Page: 161 / 584

R5905948 /12 Event Master Devices 161
Assign Menu
• Name: Adjusts the name of the Destination.
• Number of output(s): Reports the number of output
configurations in the destination.
• Dimension: Adjust the output configuration layout .
• Auto Configure Output Format: Reads the EDID
information of the connected device to acquire its
format. If the destination is composed of more than
one output,
Auto Configure Output Format
reads the format of the first output. This feature is
not available for SDI outputs.
• Format: Adjusts the output format of the
destination. This is applied to all outputs that are
added into this destination.
If you cannot find the output format in the list, it is
possible that the connector capacity for the
connector output is set below the resolution
requirements. Remove the outputs from the
Destination; update the connector capacity; and
check again. (Refer to
“ Configuration Menu >
Adjustment > Output Configuration ” , page 136,
and see the subsections "How to delete Output"
and "Output adjustment panel > Connector
Menu.")
• Output rotation icons: Adjust the counterclockwise
rotation of the Output of a Screen or an AUX
Destination. The rotation can be 0°, 90°, 180°, or
270°. The default rotation is 0°.
- When a Destination is rotated, the Output AOI
setting is reset to full, and new min and max
values are applied. For example, when an AOI
with a rotation of 0° is 1920x1080, then that
same AOI with 90° rotation is 1080x1920.
- When a Destination is rotated, the Destination
cannot be in minimum delay.
Rotation adds an extra frame of delay;
EM GUI orientation