Command reference
R&S
®
ZND
821
User Manual 1173.9557.02 ─ 61
255 - output signal at pins 8, 9, 10, 11, 16, 17, 18, 19
Range:
0 to 255
*RST:
0 (no signal)
Example:
*RST; :CONT:AUX:C 1
Assign the channel bit value 1 to the active channel no. 1. The
analyzer performs a measurement in channel no. 1, therefore
the output signal at pin 8 is switched on.
CONF:CHAN2:STAT ON; :CONT:AUX:C 2
Create channel no. 2, causing it to become the active channel,
and assign the channel bit value 2. The analyzer performs no
measurement in channel no. 2, therefore the output signal is not
changed.
CALC2:PAR:SDEF 'Ch2Tr1', 'S11'
Create a trace named 'Ch2Tr1' and assign it to channel 2. While
the analyzer measures in channel 2, the output signal changes
from pin 8 to pin 9.
Manual operation:
See
CONTrol:HANDler:A[:DATA]
<DecValue>
CONTrol:HANDler:B[:DATA]
<DecValue>
CONTrol:HANDler:C[:DATA]
<DecValue>
CONTrol:HANDler:D[:DATA]
<DecValue>
CONTrol:HANDler:E[:DATA]
<DecValue>
CONTrol:HANDler:F[:DATA]
<DecValue>
CONTrol:HANDler:G[:DATA]
<DecValue>
CONTrol:HANDler:H[:DATA]
<DecValue>
The setting commands write data to ports A, B, C, D, E, F, G, H. To write data to a port,
the port must be configured as an output port (see example). By default, the port lines
have negative logic: A "0" at a pin corresponds to a high signal, a "1" to a low signal.
The logic can be changed using
POSitive
. When writing
to port G, port C must be configured as an output port. When writing to port H, port C
and port D must be configured as output ports (see
The queries read data from ports A, B, C, D, E, F, G, H. If the port is an output port, the
queries return the last value that was written to the port.
Parameters:
<DecValue>
Decimal representation fo an n-bit binary value. The ranges are:
Port A: 0 to 255 (pins A7 ... A0)
Port B: 0 to 255 (pins B7 ... B0)
Port C: 0 to 15 (pins C3 ... C0)
Port D: 0 to 15 (pins D3 ... D0)
Port E: 0 to 255 (pins D3 ... D0 C3 ... C0)
Port F: 0 to 65535 (pins B7 ... B0 A7 ... A0)
Port G: 0 to 1048575 (pins C3 ... C0 B7 ... B0 A7 ... A0)
Port H: 0 to 16777215 (pins D3 ... D0 C3 ... C0 B7 ... B0 A7 ...
A0)
The parameters
MIN
,
MAX
,
DEF
are not supported.
SCPI command reference
www.allice.de
Allice Messtechnik GmbH