Allice Messtechnik R&S ZND, User Manual, Page: 630 / 1252

Command reference
R&S
®
ZND
630 User Manual 1173.9557.02 ─ 61
The following parameters are related to trace data (see also diagram in Chapter 4.1.5,
"Data flow" , on page 82):
Table 7-2: Data format identifiers used in the CALCulate:DATA... commands
FDATa Formatted trace data, according to the selected trace format
(
CALCulate<Chn>:FORMat
). One value per trace point for Cartesian diagrams,
two values for polar diagrams.
[Data access point 6]
SDATa Unformatted trace data: real and imaginary part of each measurement point. Two
values per trace point irrespective of the selected trace format. The trace mathe-
matics is not taken into account.
[Data access point 4]
MDATa Unformatted trace data (see SDATa) after evaluation of trace mathematics.
[Data access point 5]
NCData Factory calibrated trace data: the values are obtained right after applying the fac-
tory calibration but before applying a user-defined calibration (if any).
[Data access point 1]
UCData Uncalibrated trace data.
[Data access point 0]
Note:
●
the respective trace must represent a wave quantity or ratio
●
driving and receiving port must not be on a switch matrix
Otherwise an error occurs.
The following parameters denote the error terms generated during a calibration.
Table 7-3: Error terms in the CALCulate:DATA... commands
Error Term Description Receive Ports (S-parameter)
SCORr1, ..., SCORr12 2-port error terms; see
[SENSe<Ch>:
]CORRection:DATA
.
1 and 2 (S11, S12, S21, S22)
SCORr13 Directivity 3 (S33)
SCORr14 Source match 3 (S33)
SCORr15 Reflection tracking 3 (S33)
SCORr16 Isolation 3 (S31)
SCORr17 Load match 3 (S31)
SCORr18 Transmission tracking 3 (S13)
SCORr19 Isolation 1 (S13)
SCORr20 Load match 1 (S13)
SCORr21 Transmission tracking 1 (S13)
SCORr22 Isolation 3 (S32)
SCORr23 Load match 3 (S32)
SCORr24 Transmission tracking 3 (S32)
SCORr25 Isolation 2 (S23)
SCPI command reference
www.allice.de Allice Messtechnik GmbH