Allice Messtechnik R&S ZND, User Manual, Page: 216 / 1252

Concepts and features
R&S
®
ZND
216 User Manual 1173.9557.02 ─ 61
4.7.13 High output power for R&S ZND
Option R&S ZND-B7
With hardware option R&S ZND-B7, the output power of the R&S ZND can be signifi-
cantly increased:
Frequencies Maximum Output Power
with R&S ZND-B7 without R&S ZND-B7
≤
6.5 GHz
≥
10 dBm
≥
3 dBm
≤
7.5 GHz
≥
8 dBm
≥
6.5 GHz
≥
6 dBm
Hardware option R&S ZND-B7 can be retrofitted at Rohde & Schwarz service.
4.7.14 GPIB interface
Option R&S ZND-B10
This hardware option provides a GPIB bus connector according to standard IEEE 488 /
IEC 625 (GPIB). The GPIB bus interface can be used for controlling the R&S
ZND from
an external controller.
For interface details, refer to Chapter 12.3.3, "GPIB interface" , on page 1193.
Remote Control of External Devices via GPIB
The R&S ZND-B10 can also be used control external devices via GPIB. An additional
USB-to-IEC/IEEE adapter is only needed, if you want to control the R&S ZND via GPIB
at the same time.
4.7.15 Handler I/O (universal interface)
Option R&S ZN-B14
A network analyzer that is equipped with a Handler I/O (Universal Interface), can inter-
act with an external part handler. The digital control signals on the interface connector
indicate the possible start and the end of a measurement, as well as a global limit
check result. Typically, the handler will insert the device to be tested into a test fixture
and provide a trigger pulse to initiate the measurement. After the measurement is com-
plete, the handler will remove and replace the device and sort it into pass/fail bins. For
details, refer to
Chapter 12.3.4, "Handler I/O (universal interface)" , on page 1196.
Optional extensions and accessories
www.allice.de Allice Messtechnik GmbH