M
ANAGEMENT
I
NTERFACE
3.5.4 MLD Snooping Querier
Configuration
The MLD Snooping Querier Configuration page allows users to configure the MLD
snooping querier settings. To access this page, click
Multicast
>
MLD Snooping Querier
>
Configuration
.
Figure 3-144.
Multicast > MLD Snooping Querier > Configuration
The following table describes the items in the previous menu.
Table 3-141.
Multicast > MLD Snooping Querier > Configuration
Parameter
Description
Snooping Querier
Click the drop-down menu to enable or disable the administrative mode for MLD
Admin Mode
Snooping for the switch from the pull-down menu. The default is disable.
Snooping Querier
Enter the Snooping Querier Address to be used as source address in periodic MLD
Address
queries. This address is used when no address is configured on the VLAN on
which query is being sent.
MLD Version
Enter the MLD protocol version used in periodic MLD queries. MLD queries.
Query Interval (secs)
Enter the time interval in seconds between periodic queries sent by the snooping
querier. The Query Interval must be a value in the range of 1 and 1800. The default
value is 60.
Querier Expiry Inter-
Enter the time interval in seconds after which the last querier information is
val (secs)
removed. The Querier Expiry Interval must be a value in the range of 60 and 300.
The default value is 60.
Submit
Click
Submit
to update the switch with the values on the screen. If you want the
switch to retain the new values across a power cycle you must perform a save.
Refresh
Click
Refresh
to update the data on the screen with the present state of the data in
the switch.
192
Summary of Contents for EKI-9312P Series
Page 13: ...Hardware Installation Chapter 1...
Page 43: ...First Time Setup Chapter 2...
Page 48: ...Management Interface Chapter 3...
Page 285: ...Troubleshooting Chapter 4...
