Advantech EKI-9312P Series, User Manual

Page: 107 / 286

M
ANAGEMENT
I
NTERFACE
The following table describes the items in the previous menu.
Table 3-53. Management > LLDP > Remote Device Summary
Parameter Description
Interface Displays the local port which can receive LLDP frames advertised by a remote sys-
tem.
Remote ID Displays the remote client identifier assigned to the remote system.
Chassis ID Displays the chassis component associated with the remote system.
Port ID Displays the port component associated with the remote system.
System Name Displays the system name of the remote system.
Refresh Displays the data on the screen with the present state of the data in the switch.
Clear
Click Clear to refresh LLDP Remote Device information received on all the inter-
faces.
LLDP-MED
Global Config
Global Configuration allows users to specify the number of LLDP PDUs that can be trans-
mitted when the protocol is enabled.
To access this page, click Management > LLDP > LLDP-MED > Global Config .
Figure 3-56. Management > LLDP > LLDP-MED > Global
Config The following table describes the items in the previous menu.
Table 3-54. Management > LLDP > LLDP-MED > Global Config
Parameter Description
Fast Start Repeat Enter the number of LLDP PDUs that will be transmitted when the protocol is
Count enabled. The range is from 1 to 10. Default value of fast repeat count is 3.
Device Class Displays the local device's MED Classification. There are four different kinds of
devices, three of them represent the actual end points (classified as Class I
Generic [IP Communication Controller etc.], Class II Media [Conference Bridge
etc.], Class III Communication [IP Telephone etc.]). The fourth device is Network
Connectivity Device, which is typically a LAN Switch/Router, IEEE 802.1 Bridge,
IEEE 802.11 Wireless Access Point etc.
Submit Click Submit to update the switch with the values on the screen. If you want the
switch to retain the new values across a power cycle you must perform a save.
95