M
ANAGEMENT
I
NTERFACE
Interface Configuration
The DHCP L2 Relay Interface Configuration page allows users to enable or disable the
DHCP L2 relay mode and relay trust mode for each interface. To access this page, click
Security
>
DHCP Snooping
>
DHCP L2 Relay
>
Interface Configuration
.
Figure 3-171.
Security > DHCP Snooping > DHCP L2 Relay > Interface Configuration
The following table describes the items in the previous menu.
Table 3-168.
Security > DHCP Snooping > DHCP L2 Relay > Interface
Configuration
Parameter
Description
Interface
Click the drop-down menu to select the interface for which data is to be displayed
or configured.
DHCP L2 Relay
Click the drop-down menu to enable or disable L2 Relay mode on selected inter-
Mode
face. The factory default is Disable.
DHCP L2 Relay
Click the drop-down menu to enable or disable the L2 relay. If this is Enabled,
Trust Mode
DHCP L2 Relay application considers selected port as L2 Relay trusted. The fac-
tory default is Disable.
Submit
Click
Submit
to update the switch with the values on the screen. If you want the
switch to retain the new values across a power cycle you must perform a save.
Refresh
Click
Refresh
to update the data on the screen with the present state of the data in
the switch.
VLAN Configuration
The DHCP L2 Relay VLAN Configuration page allows users to enable or disable DHCP
L2 relay mode and circuit ID, and assign a remote ID for each VLAN ID. To access this
page, click
Security
>
DHCP Snooping
>
DHCP L2 Relay
>
VLAN Configuration
.
Figure 3-172.
Security > DHCP Snooping > DHCP L2 Relay > VLAN Configuration
222
Summary of Contents for EKI-9312P Series
Page 13: ...Hardware Installation Chapter 1...
Page 43: ...First Time Setup Chapter 2...
Page 48: ...Management Interface Chapter 3...
Page 285: ...Troubleshooting Chapter 4...
