Advantech EKI-9312P Series, User Manual

Page: 29 / 286

H
ARDWARE
I
NSTALLATION
1.7.2 Wall Mounting (Optional Kit by Request)
The wall mounting option provides better shock and vibration resistance than the DIN
rail vertical mount.
When installing, make sure to allow for enough space to properly install the cabling.
Before the device can be mounted on a wall, you will need to remove the DIN rail plate.
1. Rotate the device to the rear side and locate the DIN mounting plate.
2. Remove the screws securing the DIN mounting plate to the rear panel of the switch.
3. Remove the DIN mounting plate. Store the DIN mounting plate and provided screws for
later use.
4.
Align the wall mounting plates on the top and bottom of the rear side. The screw holes on
the device and the mounting plates must be aligned, see the following illustration.
5. Secure the wall mount plates with M3 screws, see the following figure.
Figure 1-10. Installing Wall Mount Plates
Once the wall mounting plates are secure on the device, you will need to attach the
wall screws (x4).
6. Locate the installation site and place the switch against the wall, making sure it is
the final installation location.
7. Use the wall mount plates as a guide to mark the locations of the screw holes.
8. Drill four holes over the four marked locations on the wall, keeping in mind that the
holes must accommodate wall sinks in addition to the screws.
9. Insert the wall sinks into the walls.
17