![background image](http://html1.mh-extra.com/html/abb/acs880-x04/acs880-x04_firmware-manual_3389539247.webp)
Parameters 247
M/F reference 2
(see page
13
Motor
potentiometer
(output of the motor
potentiometer).
15
PID
(output of the process PID
controller).
16
Control panel (ref
saved)
Control panel reference, with initial value from last-used panel
reference. See section
Using the control panel as an external
(page
18
Control panel (ref
copied)
Control panel reference, with initial value from previous
source or actual value. See section
(page
19
Source selection (see
). -
Parameters
configure the oscillation damping
function. See section
(page
), and the
block diagram on page
This parameter enables (or selects a source that enables) the
oscillation damping algorithm.
1 = Oscillation damping algorithm enabled
Not selected
0.
0
Selected
1.
1
DI1
Digital input DI1 (
, bit 0).
2
DI2
Digital input DI2 (
, bit 1).
3
DI3
Digital input DI3 (
, bit 2).
4
DI4
Digital input DI4 (
, bit 3).
5
DI5
Digital input DI5 (
, bit 4).
6
DI6
Digital input DI6 (
, bit 5).
7
DIO1
Digital input/output DIO1 (
, bit 0).
10
DIO2
Digital input/output DIO2 (
, bit 1).
11
Source selection (see
). -
Oscillation damping
out enable
Determines (or selects a source that determines) whether the
output of the oscillation damping function is applied to the
torque reference or not.
Note:
Before enabling the oscillation damping output, adjust
. Then monitor the input signal
(selected by
) and the output (
) to make sure that
the correction is safe to apply.
1 = Apply oscillation damping output to torque reference
Not selected
0.
0
Selected
1.
1
DI1
Digital input DI1 (
, bit 0).
2
DI2
Digital input DI2 (
, bit 1).
3
DI3
Digital input DI3 (
, bit 2).
4
DI4
Digital input DI4 (
, bit 3).
5
DI5
Digital input DI5 (
, bit 4).
6
DI6
Digital input DI6 (
, bit 5).
7
DIO1
Digital input/output DIO1 (
, bit 0).
10
DIO2
Digital input/output DIO2 (
, bit 1).
11
No.
Name/Value
Description
Def
/
FbEq16
Summary of Contents for ACS880-x04
