ABB ACS880-x04, Firmware Manual, Page: 425 / 604

Parameters 425
96.31 Drive ID number Specifies an ID number for the drive. The ID can be read by
an external controller through DDCS, for example, for
comparison with an ID contained by the controller’s
application. 0
0…32767 ID number. 1 = 1
96.39 Power up event
logging Enables/disables power-up logging. When enabled, an event
(
B5A2 Power up ) is logged by the drive upon each power-up.
Enable
Disable Power-up event logging disabled. 0
Enable Power-up event logging enabled. 1
96.51 Clear fault and
event logger Clears the contents of the event logs. See section Event logs
(page 498 ).
00000
00001 Clear the event logs. (The value will automatically revert to
00000.) 1
96.53 Actual checksum Displays the actual parameter configuration checksum. The
checksum is generated and updated whenever an action is
selected in
96.54 Checksum action .
The parameters included in the calculation have been pre-
selected, but the selection can be edited using the Drive
customizer PC tool.
See also section
Parameter checksum calculation (page 91 ).
0h
00000000h…
FFFFFFFFh Actual checksum. -
96.54 Checksum action Selects how the drive reacts if the parameter checksum
(
96.53 Actual checksum ) does not match any of the active
approved checksums ( 96.56 … 96.59 ). The active checksums
are selected by 96.55 Checksum control word .
No action
No action No action taken. (The checksum feature is not in use.) 0
Pure event The drive generates an event log entry ( B686 Checksum
mismatch ).
1
Warning The drive generates a warning ( A686 Checksum mismatch ). 2
Warning and
prevent start The drive generates a warning ( A686 Checksum mismatch ).
Starting the drive is prevented.
3
Fault The drive trips on 6200 Checksum mismatch . 4
No. Name/Value Description Def / FbEq16