![background image](http://html1.mh-extra.com/html/abb/acs880-x04/acs880-x04_firmware-manual_3389539240.webp)
240 Parameters
Enables/disables speed controller adaptation based on motor
flux reference (
.
The proportional gain of the speed controller is multiplied by a
coefficient of 0…1 between 0…100% flux reference
respectively.
See also the block diagram on page
Disable
Speed controller adaptation based on flux reference disabled. 0
Enable
Speed controller adaptation based on flux reference enabled. 1
Activates (or selects a source that activates) the speed
controller autotune function. See section
).
The autotune will automatically set parameters
,
The prerequisites for performing the autotune routine are:
• the motor identification run (ID run) has been successfully
completed
• the speed and torque limits (parameter group
)
have been set
• speed feedback filtering (parameter group
) and zero speed (
) have
been set, and
• the drive has been started and is running in speed control
mode.
WARNING!
The motor and machinery will run against
the torque and speed limits during the autotune
routine. MAKE SURE IT IS SAFE TO ACTIVATE THE
AUTOTUNE FUNCTION!
The autotune routine can be aborted by stopping the drive.
0->1 = Activate speed controller autotune
Note:
The value does not revert to 0 automatically.
Off
0.
0
On
1.
1
). -
Speed controller
autotune mode
Defines a control preset for the speed controller autotune
function. The setting affects the way the torque reference will
respond to a speed reference step.
Smooth
Slow but robust response.
0
No.
Name/Value
Description
Def
/
FbEq16
Coefficient for K
p
(proportional gain)
Flux reference
) (%)
1.000
0
0.000
100
Summary of Contents for ACS880-x04
