Parameters 119
Torque that corresponds to 100% of nominal motor torque.
The unit is selected by parameter
Note:
This value is copied from parameter
if entered. Otherwise the value is calculated
from other motor data.
-
0.000… N·m or lb·ft Nominal torque.
1 = 1 unit
Measured temperature of incoming cooling air. The unit is
selected by parameter
-
-40.0 …
200.0 °C or °F
Cooling air temperature.
1 = 1°
Amount of energy that has passed through the drive (towards
the supply) in full gigawatt-hours. The minimum value is zero.
-
0…32767 GWh
Regenerative energy in GWh.
1 = 1 GWh
Amount of energy that has passed through the drive (towards
the supply) in full megawatt-hours. Whenever the counter rolls
over,
is incremented.The
minimum value is zero.
-
0…999 MWh
Regenerative energy in MWh.
1 = 1 MWh
Amount of energy that has passed through the drive (towards
the supply) in full kilowatt-hours. Whenever the counter rolls
over,
is incremented.The
minimum value is zero.
-
0…999 kWh
Regenerative energy in kWh.
10 = 1 kWh
Amount of net energy (motoring energy - regenerating
energy) that has passed through the drive in full gigawatt-
hours.
-
-32768…32767
GWh
Energy balance in GWh.
1 = 1 GWh
Amount of net energy (motoring energy - regenerating
energy) that has passed through the drive in full megawatt-
hours. Whenever the counter rolls over,
is incremented or decremented.
-
-999…999 MWh
Energy balance in MWh.
1 = 1 MWh
Amount of energy (motoring energy - regenerating energy)
that has passed through the drive in full kilowatt-hours.
Whenever the counter rolls over,
is incremented or decremented.
-
-999…999 kWh
Energy balance in kWh.
10 = 1 kWh
Absolute value of
.
-
0.00 … 30000.00
rpm
Measured or estimated motor speed.
See par.
Absolute value of
.
-
0.00 … 1000.00%
Measured or estimated motor speed.
10 = 1%
Absolute value of
.
-
0.00 … 500.00 Hz
Estimated output frequency.
See par.
No.
Name/Value
Description
Def
/
FbEq16
Summary of Contents for ACS880-x04
