ABB ACS880 Series, Firmware Manual

Page: 282 / 764

Def / Type
FbEq 16b / 32b Description Name / Range /
Selection No.
6 Digital input DI5 ( 10.2 DI delayed status , bit 4). DI5
7 Digital input DI6 ( 10.2 DI delayed status , bit 5). DI6
10 Digital input/output DIO1 ( 11.2 DIO delayed status , bit
0).
DIO1
11 Digital input/output DIO2 ( 11.2 DIO delayed status , bit
1).
DIO2
See Terms and abbreviations (page 169) . Other [bit]
DI2 / uint32 Selects source 2 for parameter 20.1 Ext1 commands .
For the available selections, see parameter 20.3 Ext1
in1 source .
Ext1 in2 source 20.4
Not selected / uint32 Selects source 3 for parameter 20.1 Ext1 commands .
For the available selections, see parameter 20.3 Ext1
in1 source .
Ext1 in3 source 20.5
Not selected / uint16 Selects the source of start, stop and direction
commands for external control location 2 (EXT2).
See also parameters
20.7 … 20.10 .
Ext2 commands 20.6
0 No start or stop command sources selected. Not selected
1 The source of the start and stop commands is selected
by parameter
20.8 Ext2 in1 source . The state transitions
of the source bits are interpreted as follows:
Command State of source 1 ( 20.8 )
Start 0?1 ( 20.7 = Edge)
1 ( 20.7 = Level)
Stop 0
In1 Start
2 The source selected by 20.8 Ext2 in1 source is the start
signal; the source selected by 20.9 Ext2 in2 source
determines the direction. The state transitions of the
source bits are interpreted as follows:
Command State of source 2
( 20.9 )
State of source 1
( 20.8 )
Stop Any 0
Start forward 0 0?1 ( 20.7 =
Edge)
1 ( 20.7 = Level)
Start reverse 1
In1 Start; In2 Dir
3 The source selected by 20.8 Ext2 in1 source is the
forward start signal; the source selected by 20.9 Ext2
in2 source is the reverse start signal. The state
transitions of the source bits are interpreted as follows:
Command State of source 2
( 20.9 )
State of source 1
( 20.8 )
Stop 0 0
Start forward 0 0?1 ( 20.7 =
Edge)
1 ( 20.7 = Level)
Start reverse 0?1 ( 20.7 = Edge)
1 ( 20.7 = Level)
0
Stop 1 1
In1 Start fwd; In2
Start rev
282 Parameters