ABB ACS880 Series, Firmware Manual

Page: 597 / 764

Def / Type
FbEq 16b / 32b Description Name / Range /
Selection No.
1 = A custom sine filter is connected to the output of
the drive/inverter. See also parameters
97.1 , 97.2 , 99.18 ,
99.19 .
Custom sine filter b3
Reserved b4…15
1 = 1 0000h…FFFFh
Off / uint32 (Only visible with a BCU control unit)
Enables/disables router mode of the BCU control unit.
When router mode is active, the PSL2 channels
connected to another BCU (ie. those selected by
95.17
Router channel config ) are routed to the power units
(converter modules) connected to this BCU.
See section
Router mode for BCU control unit (page 146) .
Note: This parameter cannot be changed while the
drive is running.
Router mode 95.16
0 Router mode inactive. Off
1 Router mode active. On
See Terms and abbreviations (page 169) . Other [bit]
- / uint16 (Only visible with a BCU control unit)
Selects which PSL2 channels on the BCU control unit
are connected to another BCU and routed to a local
power unit.
Note: The local power units are to be connected to
successive channels starting from CH1. The other BCU
is then connected to one or more successive channels
starting from the first free channel.
Note: The lowest channel selected in this parameter is
routed to the local power unit with the lowest number,
etc.
Note: There must be at least as many local power
modules as there are routed channels.
Note: This parameter cannot be changed while the
drive is running.
See section Router mode for BCU control unit (page 146) .
Router channel
config 95.17
0 b0
1 = Channel CH2 is routed to the local power unit (which
is connected to CH1) b1
1 = Channel CH3 is routed to the local power unit (which
is connected to CH1) b2
1 = Channel CH4 is routed to a local power unit b3
1 = Channel CH5 is routed to a local power unit b4
1 = Channel CH6 is routed to a local power unit b5
1 = Channel CH7 is routed to a local power unit b6
1 = Channel CH8 is routed to a local power unit b7
Parameters 597