ABB ACS880 Series, Firmware Manual

Page: 283 / 764

Def / Type
FbEq 16b / 32b Description Name / Range /
Selection No.
4 The sources of the start and stop commands are
selected by parameters
20.8 Ext2 in1 source and 20.9
Ext2 in2 source .
The state transitions of the source bits are interpreted
as follows:
Command State of source 2
( 20.9 )
State of source 1
( 20.8 )
Start 1 0?1
Stop 0 Any
Note: The start signal is always edge-triggered with
this setting regardless of parameter
20.7 Ext2 start
trigger type .
In1P Start; In2 Stop
5 The sources of the start and stop commands are
selected by parameters
20.8 Ext2 in1 source and 20.9
Ext2 in2 source .
The source selected by 20.10 Ext2 in3 source
determines the direction. The state transitions of the
source bits are interpreted as follows:
Command State of
source 3
( 20.10 )
State of
source 2
( 20.9 )
State of
source 1
( 20.8 )
Start forward 0 1 0?1
Start reverse 1 1 0?1
Stop Any 0 Any
Note: The start signal is always edge-triggered with
this setting regardless of parameter
20.7 Ext2 start
trigger type .
In1P Start; In2 Stop;
In3 Dir
6 The sources of the start and stop commands are
selected by parameters
20.8 Ext2 in1 source , 20.9 Ext2
in2 source and 20.10 Ext2 in3 source . The state
transitions of the source bits are interpreted as follows:
Command State of
source 3
( 20.10 )
State of
source 2
( 20.9 )
State of
source 1
( 20.8 )
Start forward 1 Any 0?1
Start reverse 1 0?1 Any
Stop 0 Any Any
Note: The start signal is always edge-triggered with
this setting regardless of parameter
20.7 Ext2 start
trigger type .
In1P Start fwd; In2P
Start rev; In3 Stop
11 The start and stop commands are taken from the
control panel. Control panel
Parameters 283